BULK & wHOLESALE STEM KITS

We can use the 12 modules on the Picobricks by separating them from the split points and plugging them into the right connectors on the Raspberry Pi Pico module with a grove cable. After splitting the modules, you can communicate the modules with the Raspberry Pi Pico with the help of the grove cable.

You can develop projects using different libraries, but you can use the modules on Picobricks more easily by using the picobricks.py library we have prepared as the Picobricks Team. In addition, the picobricks.py library is used in 25 projects included in the e-book. If you are copy-pasting the Micropython codes from Picobricks Website, GitHub or e-book, you should definitely upload the picobricks.py file to Raspberry Pi Pico. To the picobricks.py library from the Picobricks GitHub page; You can reach it by following the steps PicoBricks/Software/Pre-Installed Code/picobricks.py to the picobricks.py library from the Picobricks GitHub page. How to call Picobricks library code page. In the second line, the class named SSD1306_I2c is called from the picobricks library. You need to load the picobricks.py library into the Raspberry Pi Pico by pressing the ctrl+shift+s key combination.

Picobricks, is a project development board that can be programmed on three different platforms with Microblocks, Thonny and Arduino IDE.

Click to reach the Picobricks Community page. After clicking the New Discussion tab, you can write the title and what you want to write and share it. For a more accurate assessment of your question, you can also choose a category before sharing.

To test the modules on Picobricks, Picobricks Team has created 2 different test codes using Thonny and MicroBlocks platforms. You can test your Picobricks card by using these test codes. You can go to the Picobricks GitHub page and follow the steps below to access the test code created with Thonny. Test code: PicoBricks/Software/Pre-Installed Code/test.py To reach the test code written with MicroBlocks; you can follow the steps of PicoBricks/Software/Pre-Installed Code/Microblocks Test Code/.

You don’t need to split all modules to run Picobricks modules correctly. After splitting only one or a few modules, you can use the split modules by plugging them into the corresponding connector on the Raspberry Pi Pico module with grove cables.